Manual operation name of paper gift box

Manual operation name of paper gift box

    In the gift box production process, there are many operation steps. The control of each step is the key to the production of the box body. The quality of the process control determines the quality of the gift box. The operation runs through the entire process, and the process takes the steps Connected together, this is the most exciting gift box production. The term name of the operation is;

3.3.1. Mounting paper: Before die-cutting, double-adhesive paper or other types of paper are mounted on one side of the gray board, and the inner wall of the box is white after die-cutting and forming.

3.3.2. Bottom mounting paste: paste a piece of coated paper, white card or gray-bottom white paper on the bottom of the box according to the process requirements.

3.3.3. Flannel over-paper bottom: Paste 100-120 grams of double-adhesive paper on the back of the flannel to make the flannel smooth and stiff, which is convenient for pasting operations.

3.3.4. Pack to the end: After the packing material is glued, it starts from the outside of the box, from outside to inside along the inner wall to the bottom.

3.3.5. Turn to the bottom of the bag: After the packing material is glued, it extends from the outer bread to the inner side of the box body, extends along the inner wall to the root, and then turns 90 degrees to the bottom of the inner box.

3.3.6. Wiping edge: Wipe the edge part of the box after pasting with a flannel to make the tissue wrapper fully adhere to the gray board.

3.3.7. Scrape: After the packing material is glued from the outside to the inside of the box, scrape the inside and outside of the four sides of the box with a scraper to make it adhere tightly and firmly.

3.3.8. Wipe: the process of wiping the dirty surface of the box after pasting with a flannel dipped in a little decontamination agent.

3.3.9. Glue spraying: Put the glue into the appliance, spray the glue in the form of mist through the air pressure, and evenly spray it on the surface of the load.

3.3.10. Glue brushing: the process of applying glue on the carrier with a brush.

3.3.11. Glue: The process of applying glue on the carrier in the form of a line or strip with a glue pot with a duckbill.

3.3.12. Scraping foam: The packaging material mounted on the gray board is suspended and pseudo-sticky. Use a scraper to drive away the air in the middle to make the two tightly sticky.

3.3.13. Angle pinch: After the packing material is glued, position the finalized gray board on the packing material accurately, first pick up the side with the ear, and pinch the top of the ear with the nail of the thumb. Turn the ear into the inner side to make it flat and docile. After the adjacent edge is picked up, there will be no bulge in the overlapped area.

3.3.14. Assembly: the process of pasting and fixing the finished sub-components together with the specified type of glue according to the requirements.